RANDOLPH WING WALK COMPOUND

От 7 950 ₽ до 27 525 ₽

Арт.	MPN	Описание	Цена
09-03495	20-X1567B-4	RAND X-1567 BLK WING WALK GAL	26 370 ₽
09-03494	20-X1567B-3	RANDOLPH WING WALK COMPOUND	7 950 ₽
09-00824	20-X1567G-4	RAND X-1567 WING WALK GRAY GAL	27 525 ₽
09-00823	20-X1567G-3	RAND X-1567 WING WALK GRAY QT	10 695 ₽

Описание

Black Wing Walk Compound is a special grit mixed into a tough enamel material. Used to form non-slip surfaces on airplane wing walks. Apply with a coarse brush directly over regular finish after thoroughly cleaning the surface, and breaking the glaze if the surface is old. Thin with toluene as required. Conforms to MIL-W-5044. Available in grey or black and in quart or gallon sized.

Отзывы Оставить отзыв

Отзывы ещё не добавлены

Вопросы и ответы

How much Toluene per quart of Randolph wing walk compound do I need? Or is it mostly for prep and clean up?

The wing walk compound is ready to use out of the can, but it can be thinned 5 to 1 with Toluene if the application requires it.

Regarding the Randolph Wing Walk Compound: Is it necessary to remove the old wing walk paint or should I just wipe clean with solvent and apply paint?

It can be used over itself, as long |as the surface is cleaned properly and there is no contamination.

How many square feet does one gallon of the Randolph Wing Walk Compound cover?

It depends on how thick the coats you use are, but a general guide would be one unthinned gallon covers approximately 150 square feet with one coat.

What is the temperature range for applying Randolphs wing walk?

It can be applied at any temperature. The vapors will hang around and stink up the place when the temperature is below 65 degrees F and the lower the temperature the longer it takes to dry. 65-90 degrees F is optimum.

What product do you recommend to use for cleaning/prepping a surface with pre-existing walk compound?

To clean and prep a pre-existing walk compound you will just need to dust it off and clean with soap and water. If you wanted to remove the walk compound, you will then need to heat it up and physically scrape it off.

Will this Randolph Wing Walk adhere well to bare steel, such as the step on my 170, or does it require a primer?

Primer would be best, but not required.

Is Wing walk waterproof? Is it effected by moisture?

It is oil based so it is pretty waterproof when dry.

Is there a shelf life for the X1567 Wing Walk?

Yes, the shelf life is two years from the date of manufacture.

How long does it take to dry and completely be able to walk on?

Per the Ceconite How To Manual, it dries overnight, can be walked on after 24 hours, but suggests using caution the first week, it will be a little tacky.

Can it be applied in direct sun when the plane surface might be 150-180F or best apply on a shady day or hangar?

Per Randolph: For best results, apply in a controlled environment.

What is the time between coats on the Randolph Wing Walk?

Per the application instructions, "Apply multiple coats until the desired non-skid surface is achieved. Apply all coats in one day, or wrinkling may occur."

Is this Randolph Wing Walk classified hazardous for shipping by air?

Yes, this Wing Walk is considered dangerous goods for air shipping.